Since this process is irreversible be careful not to remove too much material from the door.
How to take a sliding screen door off its hinges.
Unscrew the top hinge from the frame.
Work a flat head screwdriver under one of the wheels lift it and angle the door slightly until the wheel clears the track.
Provia installation support manager conrad mast demonstrates.
These can be allen bolts phillips or flat head screws that when turned one way or the other lower or raise the runner wheels inside the door where they contact with the track itself.
Then use your screwdriver to unscrew the head stop located at the top of the door frame.
Insert the tip of a 16d nail into the hole at the bottom of the hinges.
Remove the door from its hinges and use a wood plane to shave off thin layers of wood from the problem area until the desired thickness is achieved.
Open the door to carefully remove it.
Continue to tap it up gradually increasing the force until the pin is finally lodged upwards.
Taking a hammer and your nail punch gently ram the pin upwards.
Tap the nail with a hammer to pop the head of the pin out by about.
Pull the door up until you can see the bottom wheels on either side.
To get a sliding screen door out of the track you will have to adjust the wheel screws that are located on the four corners of the door frame itself.
Force the pin up from the door hinge.
Insert a flat blade screwdriver beneath the screen door or the bottom rollers to act as leverage when lifting the door into the track if.
To remove a sliding screen door find the screws at the bottom corners and unscrew them with a screwdriver.
Spring loaded hinges are always spread out like a butterfly and mounted flat on the outer frame.
Check the pneumatic closer.
The hole is directly underneath the head of the hinge pin.
Lay the door on a flat surface and unscrew the hinges from the door.
Repeat with the other wheel then angle the bottom of the door out and remove the door.
Unscrew the screws holding the bottom hinge to the door frame using a phillips screwdriver.
Put the flat end of the nail against the pin and tap it up with the hammer.