Brush or roll paint onto all four edges.
How to sand a 6 panel door.
Use 120 grit sandpaper to gently sand the door for a smoother surface that will absorb primer or paint more easily.
Put down drop cloths.
It s so easy in fact that this clip can present a complete overview of the process in just over two and a half minutes time.
Lightly sand the primer with 220 grit inspecting as you go.
Back off the sandpaper and use a synthetic steel wool 3m multi flex is what i use for the raised panel and detail parts of the door.
Brush on the second coat following the same order and let it dry overnight.
Remove the hinges deadbolt door knob and any other hardware.
For more and better information take a look.
Fill holes and repair imperfections with sandable filler or spackle.
Brush all of the sanding dust off of the door with an old soft bristle paintbrush or use a shop vac to suction it off.
This free video diy guide provides some much need help.
After sanding remove dust from the area before priming or painting.
Place a 220 grit sanding disc on the orbital sander and sand all of the flat areas again.
Sand the door again with 150 grit followed by 220 grit sandpaper.
Use a section of 220 grit hand sandpaper to sand the area around the raised panels.
Turn the door over and repeat all of the previous steps.
When that s dry reattach the door hardware.
The main goal is to give your door a little tooth for the new paint or primer to adhere to.
Use a hand figuring out how to go about refinishing a pine door.
Dust the door and wipe it down with a tack cloth.
No need to bust out the power sander you can use a sanding block or sheet of sand paper.
Take the door off the hinges and place it horizontally on sawhorses.
Sand the door down to bare wood with 100 grit sandpaper.
For cracks in the door scrape or sand off any rough or raised edges.
Hand sand small spots or leave them and sand it while sanding your door.
Let the primer dry overnight before sanding.
Lightly sand the entire door.
A good sand job on a heavily detailed cabinet door shouldn t take more than 15 minutes 7 8min per side.
A couple of quick passes is all it takes.
Spread the wood filler and allow it to dry.
Wipe off the door with a damp rag to remove any sawdust.
The longer it dries the better it will sand.
Paint the edges and wipe off the slop.
Before painting clean the door with a degreasing cleaner.