How To Remove Door Panel On 2003 Chevy S10

Open the glove box and push upward on the spring located at the compartment s left end to release the door from the compartment.

How to remove door panel on 2003 chevy s10.

Use a flat blad screwdriver and pry the power switch panel at front edge to release spring clip. Remove trim panel armrest screws. Remove inside door handle bezel by sliding it forward. The s 10 door panel is attached to the door by seven clips three on each side and one along the bottom.

Push the tool back to release the clip. 98 04 chevy blazer s10 gmc sonoma door panel arm rest rh passenger graphite fits. Pull switch panel up from door trim panel and disconnect the electrical connector. Remove the inside door handle bezel retaining screw.

Pull the trim bezel off the panel unplug any electrical connectors behind it then pull the bezel back sharply to remove its clips from the panel. 2003 chevrolet s10 5 out of 5 stars 2 2 product ratings 98 04 chevy blazer s10 gmc sonoma door panel arm rest rh passenger graphite. Below are directions on removing the door trim panel.