Insert the exterior part of the lock into the door by feeding the long metal piece through the opening in the center of the bolt.
How to put together a front door handle.
Put your tape measure on the floor in front of your door and measure up 41 inches from the floor since this is the most common placement for door handles.
Line up the spindle on the back of the handle with the slot in the latch sliding any mechanisms up or down as needed to fit the handle onto the door.
The flat surface of the latch should be on the interior side of the door.
If your new door handle attaches to the door at a point below the lower borehole like ours you may need to drill another hole to accommodate.
The strike plate is a rectangular metal piece that.
This is the exterior portion of your hardware with the spindle extending from the back.
If the deadbolt comes with an interior plate and a decorative outer plate with a recessed screw just place the interior plate over the hole from the inside.
If the new latch mechanism is longer than the old one drill about 1 2 inch in.
Depending on the door you may also need to remove the strike plate to take it out remove the top and bottom screws with a screwdriver and lift it carefully out of the door.
Storm doors offer protection for your exterior doors and they can be stylish and functional at the same time they have the advantage over screen doors because they let in a lot of light without allowing warm or cold air to escape thus helping to save energy.
Installing a door handle is a relatively easy home project that you can do with a pre made kit.
The spring operated bolt with a beveled face to permit a latching action when the door closes.
Watch this step by step video guide from bunnings warehouse and learn how to make sure the handles.
This is the interior portion of your knob or lever for privacy knobs and levers you ll want to be sure the push button lock is on the inside.
If you have not already removed the old door knob and latch take it out before you begin installing the new one.
Read your door handle instructions to determine if the handle hole should measure 2 3 8 inches or 2 3 4 inches from the edge of the door.
The handle will stay in place leaving your hands free to secure the interior trim.
Step 3 put new latch mechanism in.
This guide will show you how to install a storm door.
Align the spindle on the back of the assembly with the throughbolt and the slot in the latch.
Remove the old door knob latch and strike plate.
Next you ll install the outside handle assembly.
Normally 1 2 inch is sufficient.
Put the new latch assembly in the old latch hole.
Installing a door handle is a relatively easy diy project.
Slide the adjustable throughbolt up or down as needed and press the handleset onto the door.