Remove the floor keeper from your sliding door using a screwdriver.
How to put sliding security door back on track.
Both types of doors seldom have a bottom track.
It is best to apply wd 40 or silicone lubricant to the track a.
Lower the door when both wheels are on the track.
Two sets of rollers are affixed to both the top and the bottom and these roll or ride along the track.
Raise the wheel by turning the adjustment screw counterclockwise.
Bifold doors consist of two pairs of hinged panels that pivot on a pair of pins.
First locate the adjustment screws along the bottom of the outside face of the door frame shown or on the door s inside edge.
Sliding bypass doors hang from rollers that glide on a track hidden inside the top jamb of the door frame.
A sliding glass door glides back and forth along a track.
If there is a head stop or latch at the top make sure.
Step 4 lift the sliding glass door up and set the bottom edge of it into the bottom track.
If you don t lower the wheels the door will fall out of the frame when you try to open or close it.
If your closet door has one you need to remove it before you can put your door back on the track.
After you lower the door lower the wheels by turning each screw clockwise to secure the door in the frame.
A plastic guide attached to the floor typically keeps the door in place.
Check to ensure that the bottom of the door frame is not dragging on the track.
These flush bolt floor keepers are typically located on the bottom of the door in the center and prevent them from swinging at 15 to 30 degree angles.
During pleasant weather you can leave the glass open and close the sliding screen door to protect you from unwanted visitors such as.
Reinstall the sliding panel by inserting the top of the panel into the top track and lifting the door onto the track.
Turn each screw counterclockwise to raise the wheels and lower the door so that you can lift the door up and out of the track.
With the door set aside vacuum up any debris and wipe the track clean.
Step 5 tilt the door upward bracing it with your body and press it into the top track.