How To Properly Adjust Garage Door Springs

When garage doors won t close all of the way or they close unevenly spring adjustment may be called for.

How to properly adjust garage door springs.

Adjust the spring into the proper position and make sure your garage door closes all of the way. If it was opening too quickly move it to the next lower hole. If the garage door isn t opening or closing properly then check the tension on the torsion springs for needed adjustments you may need to have someone helping you to adjust the torsion spring because it can be potentially dangerous. Garage door springs are used to offset the weight of the door.

A problem with the spring tension could cause the door to open or close unevenly improperly or at the wrong speed and adjusting the springs will likely solve the problem. The other is attached to a pulley connected to the cable. If adjustment of the rear track hanger is necessary the door must be locked in the closed position because the weight of the door is supported by the rear hangers. Retest the door balance as you did in step 1.

How to adjust garage door tension. If the torsion springs do not increase in tension as the 1 4 turns are added to the springs then you probably have the torsion springs reversed. Once the spring is free of tension remove from its track hanger. If the tension is too loose the springs that help lift the.

Without the springs the door is very difficult to lift. Open it just as wide as you can without hitting the garage door opener s stop bolt and place a clamp on the track on both sides to keep the door in. You must release the tension on the garage door springs before attempting adjustment or replacement. The springs are located at the top inside part of the garage door.

With an extension spring door the goal is to take all the tension off the door before you even think about touching a spring you can do this by opening the door all the way and propping it up with a ladder. Adjusting an extension spring door. If the door was closing too quickly move the spring to the next higher hole on the bracket. Hold the garage door in this position by attaching a c clamp to the track at a point below the lowest door roller wheel.

You need proper tension on a garage door to operate the door by hand or with an automatic opener. Adjusting garage door extension. Adjust the springs on both sides of the door the same way. This is accomplished by opening the garage door as fully as possible until it hits the stop bolt on the track.

Detach the old spring from both ends and replace it with the new one and replace the pulleys as well if they are worn out. Adjusting garage door springs is a common repair.